Filter
Top Products
When the Indicators Provide No Help
48
Power does not turn on
The remote control does not work
Problems when projection starts
Have you pressed the [Power] button?
Press the button on the remote control or the [STANDBY/
ON] button on the projector's control panel.
Is "Key Lock" set to "ON"?
If the "Key Lock" menu command is set to "ON", none of the
control panel buttons will operate. Press the button on the
remote control.
"Setup" - "Operation" - "Lock Setting" - "Key Lock" (p.34)
Is the indicator lit orange?
Disconnect the power cord and then reconnect it. (p.6)
Check the circuit breaker to see if power is being supplied.
Do the indicators turn off and on when
the power cord is touched?
Turn off the projector's power, disconnect the power cord and then
reconnect it. If this does not fix the problem, there may be a
problem with the power cord. Stop using the projector, turn off the
main power switch, disconnect the power cord from the electrical
outlet, and contact your nearest dealer.
Problems with the remote control
Is the remote control light-emitting area
facing towards the remote control light-
receiving area when it is operated?
Face the remote control towards the remote control light-receiving
area.
The operating angle for the remote control is approximately ±30°
horizontally and approximately ±30° vertically. (Setup Guide)
Is the remote control too far from the
projector?
The operating distance is approximately 7 m. (Setup Guide)
Is direct sunlight or strong light from
fluorescent lamps shining onto the
remote control light-receiving area?
Set the projector up in a location where strong light will not shine
onto the remote control light-receiving area.
Are the batteries dead, or have the
batteries been inserted correctly?
Insert new batteries, while making sure that they face correctly.
(Setup Guide)