Filter
Top Products
Chapter 18 Authentication Policy
ZyWALL 110/310/1100 Series User’s Guide
257
Figure 152 Configuration > Auth. Policy > Add
The following table gives an overview of the objects you can configure.
Table 96 Configuration > Auth. Policy > Add
LABEL DESCRIPTION
Create new
Object
Use to configure any new settings objects that you need to use in this screen.
Enable Policy Select this check box to activate the authentication policy. This field is available for user-
configured policies.
Description Enter a descriptive name of up to 60 printable ASCII characters for the policy. Spaces are
allowed. This field is available for user-configured policies.
User
Authentication
Policy
Use this section of the screen to determine which traffic requires (or does not require) the
senders to be authenticated in order to be routed.
Source Address Select a source address or address group for whom this policy applies. Select any if the
policy is effective for every source. This is any and not configurable for the default policy.
Destination
Address
Select a destination address or address group for whom this policy applies. Select any if
the policy is effective for every destination. This is any and not configurable for the default
policy.
Schedule Select a schedule that defines when the policy applies. Otherwise, select none and the rule
is always effective. This is none and not configurable for the default policy.
Authentication Select the authentication requirement for users when their traffic matches this policy.
unnecessary - Users do not need to be authenticated.
required - Users need to be authenticated. They must manually go to the login screen.
The ZyWALL will not redirect them to the login screen.
Log This field is available for the default policy. Select whether to have the ZyWALL generate a
log (log), log and alert (log alert) or not (no) for packets that match the default policy.
See Chapter 38 on page 485 for more on logs.