Filter
Top Products
BLADEOS 6.5.2 Application Guide
140 Chapter 9: Quality of Service BMD00220, October 2010
DSCP Re-Marking and Mapping
The switch can use the DSCP value of ingress packets to re-mark the DSCP to a new value, and to
set an 802.1p priority value. Use the following command to view the default settings.
Use the following command to turn on DSCP re-marking globally:
Then you must enable DSCP re-marking on any port that you wish to perform this function
(Interface Port mode).
Note – If an ACL meter is configured for DSCP re-marking, the meter function takes precedence
over QoS re-marking.
RS G8124# show qos dscp
Current DSCP Remarking Configuration: OFF
DSCP New DSCP New 802.1p Prio
-------- -------- ---------------
00 0
11 0
22 0
33 0
44 0
55 0
66 0
77 0
88 1
99 0
10 10 1
...
54 54 0
55 55 0
56 56 7
57 57 0
58 58 0
59 59 0
60 60 0
61 61 0
62 62 0
63 63 0
RS G8124(config)# qos dscp re-marking