Filter
Top Products
BLADEOS 6.5.2 Application Guide
308 Chapter 21: Protocol Independent Multicast BMD00220, October 2010
Additional Sparse Mode Settings
Specifying the Rendezvous Point
Using PIM-SM, at least one PIM-capable router must be a candidate for use as a Rendezvous Point
(RP) for any given multicast group. If desired, the G8124 can act as an RP candidate. To assign a
configured switch IP interface as a candidate, use the following procedure.
1. Select the PIM component that will represent the RP candidate:
2. Configure the IPv4 address of the switch interface which will be advertised as a candidate RP for
the specified multicast group:
The switch interface will participate in the election of the RP that occurs on the Bootstrap Router, or
BSR (see “Specifying a Bootstrap Router” on page 309).
Alternately, if no election is desired, the switch can provide a static RP, specified using the
following command:
3. If using dynamic RP candidates, configure the amount of time that the elected interface will remain
the RP for the group before a re-election is performed:
RS G8124(config)# ip pim component <1-2>
RS G8124(config-ip-pim-comp)# rp-candidate rp-address <group address>
<group address mask> <candidate IPv4 address>
RS G8124(config-ip-pim-comp)# rp-static rp-address <group address>
<group address mask> <candidate IPv4 address>
RS G8124(config-ip-pim-comp)# rp-candidate holdtime <1-255>
RS G8124(config-ip-pim-comp)# exit