Filter
Top Products
BLADEOS 6.5.2 Application Guide
44 Chapter 2: Initial Setup BMD00220, October 2010
6. Enter the minute of the current time at the prompt:
Enter the minute as a number from 00 to 59. To keep the current minute, press <Enter>.
7. Enter the seconds of the current time at the prompt:
Enter the seconds as a number from 00 to 59. To keep the current second, press <Enter>. The
system then displays the date and time settings:
8. Turn Spanning Tree Protocol on or off at the prompt:
Enter y to turn off Spanning Tree, or enter n to leave Spanning Tree on.
Setup Part 2: Port Configuration
Note – When configuring port options for your switch, some prompts and options may be different.
1. Select whether you will configure VLANs and VLAN tagging for ports:
If you wish to change settings for VLANs, enter y, or enter n to skip VLAN configuration.
Note – The sample screens that appear in this document might differ slightly from the screens
displayed by your system. Screen content varies based on the firmware versions and options that are
installed.
2. Select the port to configure, or skip port configuration at the prompt:
If you wish to change settings for individual ports, enter the number of the port you wish to
configure. To skip port configuration, press <Enter> without specifying any port and go to “Setup
Part 3: VLANs” on page 46.
Enter minutes [55]:
Enter seconds [37]:
System clock set to 8:55:36 Wed Jan 28, 2009.
Spanning Tree:
Current Spanning Tree Group 1 setting: ON
Turn Spanning Tree Group 1 OFF? [y/n]
Port Config:
Will you configure VLANs and VLAN tagging for ports? [y/n]