Filter
Top Products
BLADEOS 6.5.2 Application Guide
312 Chapter 21: Protocol Independent Multicast BMD00220, October 2010
Example 2: PIM-SM with Static RP
The following commands can be used to modify the prior example configuration to use a static RP:
Where 225.1.0.0 255.255.0.0 is the multicast group base address and mask, and 10.10.1.1 is the RP
candidate address.
Note – The same static RP address should be configured for all switches in the group.
Example 3: PIM-DM
This example configures PIM Dense Mode (PIM-DM) on one IP interface. PIM-DM can be
configured independently, or it can be combined with the prior PIM-SM examples (which are
configured on a different PIM component) as shown in Figure 38.
Figure 38 Network with both PIM-DM and PIM-SM Components
RS G8124(config)# ip pim static-rp enable
RS G8124(config)# ip pim component 1
RS G8124(config-ip-pim-comp)# rp-static rp-address 225.1.0.0
255.255.0.0 10.10.1.1
RS G8124(config-ip-pim-comp)# exit
PIM-SM
Media
Servers
PIM-DM
Multicast
225.1.0.0/16
Multicast
239.1.0.0/16
IP 10.10.1.1
VLAN 101
Component 1
IP 10.10.1.2
VLAN 102
Component 2
IP Interface 11 IP Interface 22
PIM Enabled
BLADE Switch