Filter
Top Products
Trap Selection 5-25
Managing Ethernet MicroLAN Switches
To enable or disable the above-described traps:
1. Open the appropriate Trap Selection window.
2. Click on the check box next to the desired trap: Link State, Segmentation,
or Source Address.
An empty check box indicates that the corresponding trap is disabled;
A checked box indicates that the corresponding trap is enabled;
A check box that remains gray indicates that the associated trap will
not
be set
(to either enabled or disabled), and the current mode of mixed settings at the
port level will be maintained.
3. Click on the Apply button. The device will now issue, or stop issuing, the
indicated traps to your management workstation. Keep in mind, however, that
no traps will be issued to your management station unless the Ethernet
MicroLAN Switch’s trap table has been properly configured via Local
Management. Consult your Local Management documentation for more
information.
4. Click on the Cancel button to exit the window; note that clicking on the Cancel
button before clicking on the Apply button will close the window without
making any changes.