Filter
Top Products
The SmartSwitch 2000 Chassis View
2-48 Managing the Hub
Setting the UPS ID
You need to set the UPS ID typecode that indicates the manufacturer and model
of the UPS.
To set the UPS ID:
1. Click on next to the SET UPS ID text box. A Model number menu will
appear. Scroll to highlight the appropriate UPS ID. (Consult the manual that
was included when you purchased your UPS for the correct Model ID
number.)
2. Click on the OK button. The UPS ID you have chosen will appear in the text
box, and the UPS window will be active.
If your UPS unit does not function after you have set this ID, check the manual
you received with the UPS to ensure that you have chosen the correct UPS ID. If
you need to change the ID, follow the directions given above.
Using the Test Option
You can use the test option to activate a self-test cycle for your unit. This self-test
will check the viability of your unit and its battery.
To activate the test:
1. Click on the Test button. The unit will begin its self-test. The results of the test
will appear in the Test Result text box next to the Test button.
Using the Disconnect Option
You can disconnect the UPS attached to your SmartSwitch 2000 through its com
port, as follows:
1. Click on the Disconnect button near the bottom of the UPS window. Your
UPS will now be disconnected.
To reconnect, simply click on the OK button, or close, then re-open the UPS
window.
Redirecting Traffic on the SmartSwitch 2000
The Port Redirect window (Figure 2-19) allows you to redirect trafÞc from one or
more interfaces directly to another interface Ñ essentially mirroring the trafÞc at
the ÒredirectÓ interface. This feature is useful in that it allows you to use an
external analyzer on the ÒredirectÓ port to analyze data, without disturbing the
normal switching operations at the original source ports. The Port Redirect
window displays the interface remap table and allows you to add new entries to