Filter
Top Products
The SmartSwitch 2000 Chassis View
2-30 Managing the Hub
Figure 2-13. The Find Source Address Window
To use the Find Source Address window:
1. Enter the address you wish to find in a hex XX-XX-XX-XX-XX-XX format.
2. Click OK.
If the speciÞed MAC address is located, the port through which the address is
communicating will ßash in the port status display.
If the speciÞed MAC address is not located, a ÒCanÕt Find Source AddressÓ
message will appear.
Managing the Hub
In addition to the performance and conÞguration information described in the
preceding sections, the Chassis View also provides you with the tools you need to
conÞgure your device and keep it operating properly. Hub management functions
include setting operating parameters for Ethernet, Fast Ethernet, Gigabit
Ethernet, and COM ports; redirecting trafÞc; viewing system resources;
performing 802.1Q VLAN conÞguration; setting broadcast suppression;
conÞguring port priority; setting device date and time; and enabling and
disabling ports.
Configuring Ports
The ConÞguration options available for FDDI, Ethernet, Fast Ethernet, Gigabit
Ethernet, and COM ports allow you to conÞgure operating parameters speciÞc to
each port type: for FDDI and standard Ethernet ports, you can set the Duplex
Mode; for Fast Ethernet ports on Þrst generation devices, you can set a variety of
NOTE
If the MAC address is entered in an incorrect format, an ÒInvalid Ethernet AddressÓ
message will appear. Enter the address in the correct XX-XX-XX-XX-XX-XX
hexadecimal format.