Filter
Top Products
About this guide
xi
The
Installation and Service Guide
is intended for authorized ColorPASS and copier
service technicians installing or servicing the ColorPASS. If you are not an authorized
service technician, you should not attempt to install or service the ColorPASS.
Electronics for Imaging does not warrant the performance if the ColorPASS is installed
or serviced by non-authorized personnel.
N
OTE
:
The term “ColorPASS” is used in this manual to refer to both the
ColorPASS-Z6000 and the PS-NX6000 Color Servers.
About this guide
This guide is divided into the following topics:
•“Preface”
General information about this guide and about installing the ColorPASS.
• Chapter 1, “Introduction”
General information about the ColorPASS.
• Chapter 2, “Preparing for Installation”
Unpacking and the steps you need to take before you install the unit.
• Chapter 3, “Connecting the ColorPASS”
Connecting the ColorPASS to the copier and the network and verifying that the
system is working correctly; overview of the Control Panel.
• Chapter 4, “Service Procedures”
Removing and replacing procedures for ColorPASS components; installing
system software.
• Chapter 5, “Troubleshooting”
Common problems and ways of correcting them; startup error codes; diagnostic tools.
•Appendix A, “Specifications”
Hardware and network specifications; safety and emission compliance information.
•Appendix B, “Replacing top and side plastics”
Removing and replacing the top panel and the plastic piece of a side panel.
N
OTE
:
ColorPASS customers should not use the technical service documentation. Do not
leave your copy of the
Installation and Service Guide
at the customer site after you make a
service call.
Preface