Filter
Top Products
3-7
3
Installing additional options
Installing additional options
If the customer has purchased additional options, install those before connecting the
ColorPASS to the network. For installation instructions, see the documentation included
in each option kit.
After installing options, print the Test Page to verify that the system is operating properly.
Checking the installation at each stage makes it easier to pinpoint the cause of problems
should they occur.
Connecting to the network
The ColorPASS has an external 10/100/1000BaseT Ethernet network connector for an
unshielded twisted pair (UTP) cable. When the network cable is connected (see
Figure 3-5), the Ethernet interface automatically detects the speed of the network
environment. Network speed is indicated by two LEDs on the Ethernet network
connector. For additional network information, see the Configuration Guide.
NOTE: Only one network connector on the ColorPASS back panel is supported; the
unsupported connector is plugged to prevent inadvertent use. Do not remove the plug.
FIGURE 3-5 ColorPASS network connector
RJ-45 connector for
10/100/1000BaseT
twisted pair Ethernet
Not used