Filter
Top Products
3-8
3
Connecting the ColorPASS
TO CONNECT A TWISTED PAIR CABLE
Twisted pair (unshielded twisted pair cable for 100/1000BaseT) uses an RJ-45 connector
that connects to the back of the ColorPASS (see Figure 3-5 on page 3-7).
1. Shut down and power off the ColorPASS before connecting it to any network device
(see page 3-16).
2. Power off the copier.
3. Connect the network cable to the upper RJ-45 network connector on the back of
the ColorPASS.
A Category 5 unshielded twisted pair (UTP) network cable must be used
for 100/1000BaseT.
NOTE: Only one network port on the ColorPASS back panel is supported; the
unsupported port is plugged to prevent inadvertent use. Do not remove the plug.
4. Power on the ColorPASS and allow it to boot without interruption.
5. When Idle is displayed on the ColorPASS Control Panel, configure Setup options.
It is the network administrator’s responsibility to configure Setup according to the
network and user environment. Refer the network administrator to the
Configuration Guide for Setup information.
6. After configuring Setup options, verify the network connection.
Once the network connection has been made and the ColorPASS has the correct Setup
configuration, the ColorPASS should be available on the network.
The network administrator should perform any additional network setup, verify the
network connection, verify that the ColorPASS appears in the list of printers, and print a
few test documents from a networked computer that will use the ColorPASS. (For more
information, see the Configuration Guide.)