Filter
Top Products
29-7
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
OL-10101-02
Chapter 29 Configuring QoS
Understanding QoS
• Only one policer can be applied to a packet in the input direction.
• Only the average rate and committed burst parameters are configurable.
• Policing occurs on the ingress interfaces:
–
60 policers are supported on ingress Gigabit-capable Ethernet ports.
–
6 policers are supported on ingress 10/100 Ethernet ports.
–
Granularity for the average burst rate is 8 Mbps for Gigabit Ethernet ports.
• On an interface configured for QoS, all traffic received through the interface is classified, policed,
and marked according to the policy map attached to the interface. On a trunk interface configured
for QoS, traffic in all VLANs received through the interface is classified, policed, and marked
according to the policy map attached to the interface.
Note You cannot configure policers on the egress interfaces.
Mapping Tables
Note This feature is available only if your switch is running the EI.
During classification, QoS uses a configurable CoS-to-DSCP map to derive an internal DSCP value from
the received CoS value. This DSCP value represents the priority of the traffic.
Before the traffic reaches the scheduling stage, QoS uses the configurable DSCP-to-CoS map to derive
a CoS value from the internal DSCP value. The CoS value is used to select one of the four egress queues.
The CoS-to-DSCP and DSCP-to-CoS maps have default values that might or might not be appropriate
for your network.
For configuration information, see the “Configuring CoS Maps” section on page 29-32.
Queueing and Scheduling
Note Both the SI and EI support this feature.
The switch gives QoS-based IEEE 802.1p CoS values. QoS uses classification and scheduling to send
network traffic from the switch in a predictable manner. QoS classifies frames by assigning
priority-indexed CoS values to them and gives preference to higher-priority traffic such as telephone
calls.
How Class of Service Works
Before you set up IEEE 802.1p CoS on a that operates with the Catalyst 6000 family of switches, see
the Catalyst 6000 documentation. There are differences in the IEEE 802.1p implementation that you
should understand to ensure compatibility.