Filter
Top Products
23-40
Cisco BPX 8600 Series Installation and Configuration
Release 9.3.10, Part Number 78-11603-01 Rev. D0, July 2001
Chapter 23 Configuring BXM Virtual Switch Interface
Summary of VSI Commands
Summary of VSI Commands
VC Qdepth 61440 10,000
160–cbr
1280–vbr
CLP Hi 100 80
CLP Lo / EPD 40 35
EFCI TagAbr: 20 20 (not valid for non-Abr)
RIF Tag0–7: N/A
TagAbr: 16
Abr: 16
RDF Tag0–7: N/A
TagAbr: 16
Abr: 16
Nrm Tag0–7: N/A
TagAbr: 32
Abr: 32
FRTT Tag0–7: N/A
TagAbr: 0
Abr: 0
TBE Tag0–7: N/A
TagAbr: 16,777,215
Abr: 16,777,215
IBS N/A N/A
CAC Treatment LCN Vbr: CAC4
Ubr:LCN
Abr: MIN BW
Cbr: CAC4
Scaling Class Ubr – Scaled 1st Vbr: Vbr –Scaled 3rd
Ubr: Ubr – Scaled 1st
Abr: Abr – Scaled 2nd
Cbr: Cbr – Scaled 4th
CDF 16 16
Table 23-15 Commands for Setting up a VSI (Virtual Switch Interface) Controller
Mnemonic Description
addctrlr Attach a controller to a node; for controllers that require Annex G capabilities in
the controller interface. Add a PNNI VSI controller to a BPX node through an
AAL5 interface shelf.
addshelf Add a trunk between the hub node and interface shelf or VSI MPLS
controller.)
cnfqbin Configure Qbin card. If you answer Yes when prompted, the command will
use the card Qbin values from the Qbin templates.
cnfrsrc Configure resources, for example, for Automatic Routing Management PVCs
and MPLS controller (LSC).
Table 23-14 Service Class Template Default Settings (continued)
Parameter with Default Setting Label PNNI