Filter
Top Products
2-20
Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide
OL-2239-03
Chapter2 Configuring the Cable Modem Termination System for the First Time
Configuring the Cisco uBR7200 Series Using the Setup Facility
Step6 The Simple Network Management Protocol (SNMP) is the most widely supported open standard for
network management. SNMP provides a means to access and set configuration and run-time parameters
of routers and communication servers. SNMP also defines a set of functions that can be used to monitor
and control network elements.
Enter yes to accept SNMP management; enter no to refuse it:
Configure SNMP Network Management? [no]:
Community string [public]:
Step7 In all cases, you will use IP routing. When you are using IP routing, select an interior routing protocol.
You can specify one of only two interior routing protocols to operate on your system using the Setup
facility, either Interior Gateway Routing Protocol (IGRP) or Routing Information Protocol (RIP).
To configure IP routing, enter yes (the default) or press Return, and then select an interior routing protocol:
Configure IP? [yes]:
Configure IGRP routing? [yes]:
Your IGRP autonomous system number [1]: 15
Step8 Configure your line card interface parameters. The following example shows how an 8-port Ethernet line
card is installed in line card slot3. The Setup facility determines the status of all interfaces.
To configure each active interface port for IP, enter yes (the default) or press Return. For all inactive
ports, the default is no. You can press Return to accept the default.
Configuring interface Ethernet 1/0:
Is this interface in use? [yes]:
Configure IP on this interface? [yes]:
IP address for this interface [19.2.22.4]:
Number of bits in subnet field [8]:
Class A network is 19.0.0.0, 8 subnet bits; mask is /16
Configuring interface Ethernet1/1:
Is this interface in use? [no]:
Configuring interface Ethernet1/2:
Is this interface in use? [no]:
Configuring interface Ethernet1/3:
Is this interface in use? [no]:
Configuring interface Ethernet1/4:
Is this interface in use? [no]:
Configuring interface Ethernet1/5:
Is this interface in use? [no]:
Configuring interface Ethernet1/6:
Is this interface in use? [no]:
Configuring interface Ethernet1/7:
Is this interface in use? [no]:
Step9 Configure your cable interface. The following example shows a CiscouBR7200seriesrouter with cable
interface. The Setup facility, for the most part, determines the status of all interfaces.
To configure each active interface port, enter yes (the default) or press Return. For all inactive ports, the
default is no. You can press Return to accept the default.
Configuring interface cable 5/0:
Is this interface in use? [yes]:
Configure this interface? [yes]:
IP address for this interface [19.2.22.5]:
Number of bits in subnet field [8]:
Class A network is 19.0.0.0, 8 subnet bits; mask is /16
Configuring interface cable 1/1: