Filter
Top Products
Index
IN-6
Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide
OL-2239-02
power adjustment 3-16, 3-17
power level 3-24
PPPoE (Point-to-Point Protocol over Ethernet) 1-135
Pre-equalization Control for Cable Modems 1-94
protocols
ARP (Address Resolution Protocol)
downstream, activating 3-2
downstream, verifying 3-3
Proxy ARP 3-28
Bootstrap Protocol (BOOTP) 1-31
Dynamic Host Configuration Protocol (DHCP) 1-31
IGRP (Internet Gateway Routing Protocol) 2-20
Internet Protocol (IP) 1-8
Multicast Source Discovery Protocol (MSDP) 1-115
Network Time Protocol (NTP) 1-115
Real-Time Transport Protocol (RTP) 1-46
RIP (Routing Information Protocol) 2-20
Simple Network Management Protocol (SNMP) 1-110
Trivial File Transfer Protocol (TFTP) 1-31, 1-63
Proxy ARP 3-28
Q
Quality of Service
Cisco 1-45
DOCSIS 1.1 1-60
DOCSIS enhancements prior to DOCSIS 1.1 1-52
R
rate limiting
downstream 3-10
upstream 3-26, 3-27
reboot, router 2-9
registration timeout 5-6
RIP (Routing Information Protocol) 2-20
RTP Header Compression 1-46
S
sample configuration files 2-29, C-1
scrambler, activating 3-17
security
features 1-102
replacing or recovering a lost password 2-6
setting password protection 2-5
Service Independent Intercept 1-78
Setup facility 1-31
configuring Cisco uBR7200 series with 2-17
show commands
show cable bundle forwarding-table 3-31
show cable device 1-129
show cable host 1-129
show cable modem 1-35, 5-5, 8-7
show cable modem summary 1-35
show cable modulation-profile 1-35
show cable qos 1-35
show cable tech-support 1-41
show controllers cable 1-42
show controllers cable downstream 3-6
show int cx/y sid 1-35
show interface cable 3-33
show interfaces 1-19, 1-20
show interfaces cable 1-19
show running-config 1-16, 3-10, 3-17
show slot A-4
show tech support 1-44
understanding show command responses 8-2
slot/port numbers for interfaces 1-17
SNMP features 1-109
spectrum management 1-119
status, cable interface 2-26
downstream 1-19
upstream 1-20
symbols, defined xiv
sync message interval 5-9