Filter
Top Products
96
EMC Host Connectivity with QLogic FC and iSCSI HBAs and FCoE CNAs for the Linux Environment
Installing and Configuring the Linux Host with the QLogic Driver
a. For models QLE8240, QLE8242, QLE8250, and QLE8252 only.
Refer to the latest EMC Support Matrix for specific qualified kernel
versions and distributions.
Note: The support stated in the EMC Support Matrix supersedes versions
listed in this document.
Installation instructions for the out of kernel QLogic driver
This section contains the following information for installing the out
of kernel QLogic driver:
◆ “Installing the Linux v2.4.x host and the QLogic v3.x-Series iSCSI
HBA driver” on page 96
◆ “Installing the Linux v2.6.x host and the QLogic v5.x-Series iSCSI
HBA driver” on page 107
Installing the Linux v2.4.x host and the QLogic v3.x-Series iSCSI HBA driver
Using the QLogic iSCSI HBA with the Linux operating system
requires EMC-approved HBA driver software and SANsurfer
Management software. The driver functions at a layer below the
Linux SCSI driver to present iSCSI devices to the operating system as
if they were standard SCSI devices.
Note: Refer to the latest EMC Support Matrix for specific qualified kernel
versions and distributions. The support stated in the EMC Support Matrix
supersedes versions listed in this document.
RHEL 4.6
RHEL 5.0
5.01.01.04
SLES 11 SP1
RHEL 6.0
RHEL 6.1
5.02.11.00.05.06-c3
a
SLES 10 SP4 5.02.11.00.10.4-d2
a
Table 8 Supported iSCSI out of kernel driver versions
OS Driver version