Filter
Top Products
Introduction
7
Configuring the Network Adapter
To configure the network adapter, you must complete the
following steps. See the noted documentation for more detailed
information.
1. Install the network adapter in your printer. See Chapter 1.
2. Install EpsonNet WinAssist or MacAssist. See the
supplemental sheet shipped with the CD-ROM. Or you can
use the EpsonNet Easy Setup to configure the network
adapter without installing EpsonNet WinAssist. See Chapter
2.
3. Set the IP address for the network adapter. See Chapter 3.
4. Configure the network adapter using EpsonNet WinAssist,
MacAssist, or WebAssist and set up the printer. See the
appropriate chapter for your network environment.
5. Use EpsonNet Direct Print to print from TCP/IP. See Chapter
11.
6. Use EPSON Status Monitor 2 to monitor printer status. See
Chapter 12.
7. Use EpsonNet Internet Print to print using the Internet
Printing Protocol (IPP). See Chapter 13.
8. Use Printer Status Page to monitor printer status through the
Internet. See Chapter 14.