Filter
Top Products
Getting Started
1-4
Connecting to the Network
Follow the instructions below to install the network adapter in
your printer.
c
Caution:
❏
Do not place anything on top of the network adapter.
❏
Leave adequate room around the network adapter for easy
operation.
1. Make sure that the printer is turned off.
2. Plug the network adapter into the printer’s parallel interface
connector. Be sure to squeeze the wire clips together until they
lock in place on either side of the connector.
3. Connect the network cable to the RJ-45 connector on the
network adapter and other end to the network.
c
Caution:
You must use a Category-5 shielded twisted-pair cable to
connect the network adapter to prevent malfunctions.
Note:
❏
The network adapter is set to the default IP address
"192.168.192.168". This private IP address may cause a
conflict on your network. To prevent this, you must confirm
that the same IP address does not already exist on the network
before connecting the network adapter to the network. If it does,
turn off the device which has the same IP address, then change
the default IP address of the network adapter. See Chapter 3 for
instructions on setting the IP address.
❏
Do not connect or disconnect the network cable when the printer
is on.
❏
Be sure to use a HUB to connect the network adapter to the
network.