Filter
Top Products
EPSON Stylus Scan 2500 Revision A
Disassembly & Assembly Disassembling the Printer Mechanism 108
4.6.7 Removing the PE Paper Detector Assembly
1. Remove the housing. (Refer to Section 4.3.)
2. Release two fixed hooks securing the PE detector assembly from the back
of the frame and remove the PE detector assembly, sliding it upward.
Remove the PE board assembly and PE lever, if necessary.
Figure 4-16. Removing the PE Detector Assembly
CHECK
POINT
During assembly, make sure that the tip (sensor part) of
the detector lever is in the hole of paper guide assembly.
After releasing two hooks, remove
the PF paper detector assmebly,
sliding it upward.
(From back side of
the frame)
PE Holder
This side should
be installed on the
frame.
Torsion Spring 0.22
PE Lever
PE Board Assembly