Filter
Top Products
EPSON Stylus Scan 2500 Revision A
Maintenance Overview 131
7
<Lubrication Point>
Both Left/Right Bushings for
“ROLLER, EXIT”
Avoid applying grease around the
paper path.
Use a syringe to apply it.
134
<Lubricant Type> G-26
<Lubrication Amount>
Evenly apply inside the bushings.
8
<Lubrication Point>
Contact points between
“HOLDER, PULLEY, DRIVEN” and
“FRAME, UPPER”
Verify that the holder slides only
with spring force after applying
grease.
Use a syringe to apply it.
135
<Lubricant Type> G-26
<Lubrication Amount>
2-mm long for each point
9
<Lubrication Point>
ASF;
The round hole in the right frame
of ASF (to hold the roller shaft)
Avoid applying grease to
“ROLLER, ASSEMBLY, LD”.
135
<Lubricant Type> G-26
<Lubrication Amount>
Evenly apply inside the hole.
10
<Lubrication Point>
ASF;
Contact points between
“HOPPER” and “LEVER, HOPPER,
RELEASE”
Completely wipe off any grease
sticking out to the inner side of
ASF.
135
<Lubricant Type> G-26
<Lubrication Amount>
Evenly apply lubrication to the
points.
Table 6-4. Lubrication Points (cont.)
No. Standard Remarks
See
pag
e
11
<Lubrication Point>
The round cutout in the left frame
of ASF (“GEAR, 34” is inserted to
the cutout.)
Completely wipe off any grease
sticking out to the inner side of
ASF.
136
<Lubricant Type> G-26
<Lubrication Amount>
Evenly apply inside the hole
12
<Lubrication Point>
Oil pad in the carriage assembly
Lubricate the oil pad only when:
Replacing the carriage assembly
Replacing the oil pad
Use a precise syringe to apply oil.
If you accidentally apply too much
oil to the oil pad, throw the pad
away and take a new one again.
Leave the pad for a while to wait
until oil is evenly infiltrated, then
install it on the carriage assembly.
136
<Lubricant Type> O-12
<Lubrication Amount>
0.72 ~ 0.77cc (0.65 ~ 0.69g)
Note:
This is the amount to be applied
to a new oil pad.
Table 6-4. Lubrication Points (cont.)
No. Standard Remarks
See
pag
e