Filter
Top Products
EPSON Stylus Scan 2500 Revision A
Adjustment Using the Service-Adjustment Program 122
5.3.3 Initial Ink Charge Operation
There is no ink in the ink path of a spare printhead and printer mechanism
when first installed; therefore, after replacing either of these two parts, you
need to perform an initial ink charge.
1. Enter the Production menu as described in “Using the Service-
Adjustment Program” on pag e116.
2. On the Production menu (Figure 5-6), select Ink Charge. Then click OK
in the dialog box that appears.
5.3.4 Bi-D Adjustment
You perform this adjustment to correct differences in printing positions,
which is caused by slippage of printing timing in right and left directions
during the Bi-directional printing. Therefore, you need to perform this
adjustment after performing the following operations.
Replacing the printer mechanism
Replacing the main board
Replacing the CR motor
Replacing the Carriage Assembly
Replacing the Printhead
1. Enter the Production menu as described in “Using the Service-
Adjustment Program” on page 116.
2. On the Production menu (Figure 5-6), select Bi-d Adj. - Normal. The Bi-
d Adjust dialog box appears.
3. Click OK in the dialog box that appears to print adjustment patterns
with the current settings.
It takes approximately 90 seconds for the ink charge
operation to complete.