Filter
Top Products
CONFIDENTIAL
Paper roll Status commands GS a
Ver. 10.01 p. 324
TM-T88III
The default value is set by DIP switch 2-1.
■ Second byte (printer information)
Bits 0 and 2 of the second byte are undefined.
■ Third byte (paper sensor information)
When the roll paper cover is open, paper detection (detected by the roll paper end sensor) may be
incorrect.
TM-L60II
With a serial interface, the default value is set by DIP switch 2-1.
With a parallel interface, the default value is set by DIP switch 1-3.
■ Second byte (printer information)
Bits 0, 1 and 3 of the second byte are undefined.
TM-P60
The function of Bit 0 of parameter (
n
) is not supported. Specify 1 to bit 0 of n or bits of
“Reserved.”
■ First byte (printer information)
Bit 2 status is as follows:
■ Basic second byte (printer information)
Bits 0 and 2 of the second byte are not supported.
n:
Bit Binary Hex Decimal Function
2 0 00 0 Does not go to offline by low battery. ... how to use
this table
1 04 4 Offline by low battery.