Filter
Top Products
CONFIDENTIAL
Paper roll Counter printing commands GS C ;
Ver. 10.01 p. 641
[Recommended Functions]
This command is supported by some printer models and will not be supported by future models.
Future models will not support counter value.
[Notes]
■ In count-up mode, the counter value exceeds the maximum counter value (
sb
), the printer restart
counting from the minimum counter value
(
sa
).
■ In count-down mode, the counter value is below the minimum counter value (
sb
), the printer
restart
counting from the maximum counter value
(
sa
).
■ counter value and
sa
is the maximum counter value.
■ In count-stop mode, the counter value is not changed by GS c.
■
sa
,
sb
,
sn
,
sr
, and
sc
specify a value using a decimal character string, respectively.
■
sa
,
sb
,
sn
,
sr
, and
sc
can be omitted (“;“ which separates an argument, cannot be omitted). Setting
value for the omitted argument is not changed.
Example:
When changing only a stepping amount for a count-up or count-down and a counter value, the setting
value is [GS C ; ; ; 5 ; ; 100 ;].
■ The internal counter value which counts the repetition number of printing by processing this command
is “0”.
■ The counter value range (maximum value and minimum value), stepping amount of incrementing or
decrementing of a counter value, and repetition number of printing are effective until GS C 1 is executed,
ESC @ is executed, the printer is reset, or the power is turned off.
■ the value of the serial number counter set by this command is effective until GS C 2 is executed, ESC @ is
executed, the printer is reset, or the power is turned off.
■ The Value of the counter is updated when executing GS c.