Epson TM-U210 Printer User Manual


 
CONFIDENTIAL
Paper roll Miscellaneous commands GS P
Ver. 10.01 p. 470
GS P
SETTING COMMAND
[Name] Set horizontal and vertical motion units
[Format] ASCII GS P
x
y
Hex 1D 50
x
y
Decimal 29 80
x
y
[Range] 0
x
255
0
y
255
[Default] TM-J2000/J2100, TM-T88III, TM-L60II:
x
= 180,
y
= 360
TM-T90:
x
= 180,
y
= 360 [Other than Japanese model]
x
= 203,
y
= 406 [Japanese model]
TM-L90:
x
= 203,
y
= 406
[Printers not featuring this command] TM-P60, TM-U230, TM-U220, TM-U210, TM-U300A/B
[Description] Sets the horizontal and vertical motion units to approximately 25.4/
x
mm {1/
x
"} and approximately 25.4/
y
mm {1/
y
"}, respectively.
When
x
= 0, the default value of the horizontal motion unit is used.
When
y
= 0, the default value of the vertical motion unit is used.
[Notes]
The horizontal direction is perpendicular to the paper feed direction and the vertical direction is the paper
feed direction.
The horizontal and vertical motion units indicate the minimum pitch used for calculating the values of
related commands (shown on the next screen).
In standard mode, the following commands use
x
or
y
.
Commands using
x
: ESC SP, ESC $, ESC \, GS L, and GS W
Commands using
y
: ESC 3, ESC J, ESC K, GS A and GS V
In page mode, the following commands use
x
or
y
, when the starting position is set to the upper left or
lower right of the print area using ESC T.
Commands using
x
: ESC SP, ESC $, ESC W, ESC \ and FS S.
Commands using
y
: ESC 3, ESC J, ESC K, ESC W, GS $, GS A, GS V, and GS \
Miscellaneous commands