Filter
Top Products
156
Location Recorder Model PD606
Chapter 8: MENU mode/SYS SETUP menu
The “Auto part. link” menu item allows you to enable or disable the auto partition link func-
tion. By setting this item to "On" (while the default is "Off"), when there is no recording space
left in the current partition during recording (after approximately 4.5 GB recording), the unit
automatically creates a new file in the next available partition and continues recording to it.
Therefore, you can make long recording which exceeds the capacity of a partition.
Continuous recording function [Auto part. link]
<Note>:
You can make continuous recording by setting the “Auto part. link” item to “On”
only when recording to a partition on the internal hard disk. It is not possible to make
continuous recording when recording to a DVD-RAM disk. Also note that continuous re-
cording is not possible when carrying out the auto copy function or dual drive recording.
Off
On
At the point when there is no remaining space left on the current partition, the unit
continues recording on the next partition.
Selectable between “On” and “Off” (the default is “Off”).
Options
1) While the unit is stopped, press the [SHIFT] key to light the SHIFT indicator, followed by the
[ENTER/YES] key.
2) While “SYS SETUP” is highlighted, press the [ENTER/YES] key.
The display now shows the SYS SETUP menu screen.
5) Press the [EXIT] key repeatedly until you exit the MENU mode.
4) Use the [MENU] dial to select the desired option and press the [ENTER/YES] key to confirm
your setting.
3) Use the [MENU] dial to select the “Auto part. link” menu item and press the [ENTER/YES] key.
The current setting starts flashing and you can now select the desired option.
At the point when there is no remaining space left on the current partition, recording
ends.
Flashing