Filter
Top Products
190
Location Recorder Model PD606
Chapter 8: MENU mode/TC SETUP menu
Using the "Default LTC start" menu item, you can set the desired default LTC start time value
(the initial setting is "1h 00m 00s"). This value is used when the generator mode is set to "Ext
Run" but no external time code is fed to the unit.
3) Press the [ENTER/YES] key again.
The second value flashes and you can now edit the default LTC start time.
<Note>:
The unit does not recognize paused time code as "correct" time code.
It recognizes time code when receiving more than two continuous frames.
Default LTC start time setting [Default LTC start]
2) Use the [MENU] dial to select the “Default LTC start” menu item, and press the [ENTER/YES] key.
The current LTC start time is shown (initially, "01h 00m 00s" is shown).
1) When the unit is stopped, press the [SHIFT] key to light the [SHIFT] indicator, followed by the
[TIME/
TC SET] key.
The display now shows the TC SETUP menu screen.
4) Edit the time value to the desired value, and press the [ENTER/YES] key to confirm your
setting.
Use the [MENU] dial (or the alphanumeric keys) to enter a desired value and use the
[
] / [
] keys to move the cursor position.
The setting is stored to the Flash ROM of the unit.
5) Press the [EXIT] key repeatedly until you exit the MENU mode.
Flashing