Filter
Top Products
165
Location Recorder Model PD606
Chapter 8: MENU mode/SYS SETUP menu
Use the [MENU] dial to select the desired option and press the [ENTER/YES] key to
confirm your setting.
If a write error occurs while you set "Write error" to "On",
the warning tone is output by the pattern on the right.
You can select between “On” and “Off” (the default is “On”).
Options
The “Error tone” menu item selects whether generating the error tone (warning tone) or not for
each of four kinds of troubles (see below) independently.
Error tone output setting [Error tone]
• Write error On or Off setting
Use the [MENU] dial to select the “Write error” and press the [ENTER/YES] key.
The current setting starts flashing and you can now select the desired option.
Flashing
3) Use the [MENU] dial to select the “Error tone” menu item and press the [ENTER/YES] key.
You can select “On” or “Off” of the error tone for “Write error”, “Input clip” and “BATT
warning”, as well as can set the time for “Disk warning”.
1) While the unit is stopped, press the [SHIFT] key to light the SHIFT indicator, followed by the
[ENTER/YES] key.
2) While “SYS SETUP” is highlighted, press the [ENTER/YES] key.
The display now shows the SYS SETUP menu screen.
1. A write error happens during recording. [Write error]
2. The peak indicator lights due to input overload during analog recording or clipping of the stereo
buss. [Input clip]
3. The battery voltage drops below the threshold voltage set by the "BATT. warning" menu item. [BATT
warning]
4. The remaining recording time of a disk (or a partition) gets under the specified time. [Disk warning]