Filter
Top Products
25
Location Recorder Model PD606
Chapter 2: Preparation before using the PD606
Power supply priority setting (essential when using both [DC IN] and a battery)
When you use both a battery and the [DC IN] connector, you must set the power
supply priority ("DC-IN" or "BATT"). For example, if you set it to "DC-IN", the battery
automatically takes over only when the power supply from the "DC-IN" jack is cut off
(power failure, disconnection, etc).
Note that, if you use only batteries, you do not need to make this setting.
You can make setting via the "Power priority" item in the "BATTERY SETUP" menu of
the MENU mode (see page 174).
Protector adjustment
When the battery is mounted, pull out the protector to protect the battery, as shown
below. While sliding the [ADJUST] levers on left and right side panels to the arrow
direction, pull out the protector. There are two locked positions for the protector.
Set it to the appropriate position. Note that you should push it down when replacing
the battery.
[ADJUST] levers
Protector
E
TUO
TSUJDA
<Note>:
The protector can protect the IDX ENDURA-7 and ENDURA-7S. When you
use the ENDURA-10 or ENDURA-10S, or PowerLink is active, we recommend using
the PD606 horizontally.