Filter
Top Products
96
www.gateway.com
7 Locate the old battery on the system board and note its orientation. You will need
to install the new battery the same way.
8 Push the battery retention clip away from the battery until the battery lifts up, then
remove the old battery. You can use a screwdriver to help lift the battery.
9 Make sure that the positive (+) side of the new battery is facing up, then press the
new battery into the socket until it snaps into place.
10 Replace the PCI riser assembly by following the instructions in “Removing and
installing the PCI riser assembly” on page 69.
11 Follow the instructions in “Closing the server case” on page 44.
12 Turn on your server, then press F2 when the Gateway logo screen appears during
startup. The BIOS Setup utility opens.
13 Restore any BIOS settings that you wrote down in Step 3.
14 Save all your settings and close the BIOS Setup utility.
CMOS
battery
8510522.book Page 96 Wednesday, March 16, 2005 11:19 AM