Filter
Top Products
94
www.gateway.com
7 Slide the backplane to the left until it stops.
8 Holding the backplane by the edges only, lift it from the chassis.
9 Place the backplane in a static-free bag to store it for future use.
10 Holding the new backplane by the edges only, align it with the stand-offs on the
chassis, then place it on the stand-offs and slide it to the right until it stops.
11 Tighten the blue captive thumbscrew in the center of the backplane.
12 Reconnect all cables to the backplane.
13 Follow the instructions in “Closing the server case” on page 44.
14 Reinstall the hot-swap drives back into the server. Make sure that you install the drives
into the same bays you removed them from in Step 4. For instructions see “Installing
a hard drive” on page 60.
15 Replace the bezel by snapping it into place on the front of the server.
Caution Pressing or pulling on any components on the backplane could result
in damage to the backplane.
Caution Pressing or pulling on any components on the backplane could result
in damage to the backplane.
Caution Make sure you do not pinch, bind, or damage any cables as you install
the backplane.
8510522.book Page 94 Wednesday, March 16, 2005 11:19 AM