Filter
Top Products
58
www.gateway.com
11 Remove the two screws securing the interposer board to the back of the CD or DVD
drive, then remove the interposer board.
12 Follow the instructions in “Installing a CD or DVD drive” on page 58.
- OR -
Install a slim-line drive bay filler panel into the empty bay.
13 Reinstall the bezel, if required, by snapping it into place on the front of the chassis.
14 Follow the instructions in “Closing the server case” on page 44.
15 Reconnect all power cords and peripheral device cables, then turn on the server.
Installing a CD or DVD drive
To install a CD or DVD drive:
1 Follow the instructions in “Preventing static electricity discharge” on page 41. Make
sure that you turn off the server, then unplug the power cord(s) and all other cables
connected to the server.
2 Follow the instructions in “Opening the server case” on page 42.
3 Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
4 Remove the CD/DVD drive carrier by pressing the blue lever at the back of the carrier
and pushing the carrier out the front of the server.
Caution The CD or DVD drive is not hot-swappable. Before installing or
removing the drive, make sure that power is turned off and the power
cord is unplugged.
8510522.book Page 58 Wednesday, March 16, 2005 11:19 AM