Filter
Top Products
16
www.gateway.com
8 With the front of the server facing you, lift the server and insert it into the cabinet
from the front, then position the disk guides so they fit in the cabinet rails. (Your
server may be different than the server shown in the example.)
9 Install a nut bar or mounting nuts on the front cabinet posts.
10 Push the server toward the back of the cabinet until the front of the server rails touch
the front cabinet posts, then secure with two screws through each server rail.
- OR -
Follow the instructions in “Installing the bezel” on page 17 to attach both handles
and secure the server into the cabinet.
Warning You must support the server while installing or removing the front
screws and while sliding the server on or off the cabinet rails. If the
server is not supported, damage to the server or injury may result.
Nut bar or mounting nuts
8510522.book Page 16 Wednesday, March 16, 2005 11:19 AM