Filter
Top Products
102
www.gateway.com
Replacing the system board
To replace the system board:
1 Follow the instructions in “Preventing static electricity discharge” on page 41. Make
sure that you turn off the server, then unplug the power cord(s) and all other cables
connected to the server.
2 Follow the instructions in “Opening the server case” on page 42.
3 Remove the processor air duct by following the instructions in “Removing the
processor air duct” on page 45.
4 Remove the PCI riser assembly by following the instructions in “Removing and
installing the PCI riser assembly” on page 69.
5 Remove the memory modules by following the instructions in “Installing memory”
on page 66.
6 Remove the fan module by following the instructions in “Replacing fans and fan
modules” on page 76.
7 Remove the heat sinks and processors by following the instructions in “Installing a
processor” on page 82.
8 Disconnect all cables from the system board, noting their locations and orientation.
(You will reconnect the cables after you install the new board.)
8510522.book Page 102 Wednesday, March 16, 2005 11:19 AM