Filter
Top Products
52
www.gateway.com
Installing a diskette in a converted hard drive bay
If you need to install a slim-line diskette drive into your server, you must install the diskette
drive in the center hard drive bay.
To install a diskette drive in a converted hard drive bay:
1 Follow the instructions in “Preventing static electricity discharge” on page 41. Make
sure that you turn off the server, then unplug the power cord(s) and all other cables
connected to the server.
2 Follow the instructions in “Opening the server case” on page 42.
3 Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
4 Remove the center hot-swap hard drive carrier from the server.
5 xxxRemove the rails from the diskette drive conversion kit carrier by removing the
four screws that secure the rails to the carrier.
Caution The diskette drive is not hot-swappable. Before installing or removing
the drive, make sure that power is turned off and the power cord is
unplugged.
8510522.book Page 52 Wednesday, March 16, 2005 11:19 AM