Filter
Top Products
87
www.gateway.com
6 Find the IMM connector on the left back portion of the system board.
7 Grasp the module by the edges, close to the mounting connector, align the module
with the IMM connector on the system board, then gently apply pressure to seat the
module.
Make sure the module is fully seated and the nylon standoff is inserted into the
corresponding hole in the system board.
8 Replace the riser assembly by following the instructions in “Removing and installing
the PCI riser assembly” on page 69.
9 Follow the instructions in “Closing the server case” on page 44.
10 Following the installation of a new IMM module, reinstall the GSM software (supplied
on a CD with your server) and update the FRU/SDR (see “Updating the FRU/SDR” on
page 37). When you subsequently reboot your server, the GSM software will take over
management of the server.
Caution Exercise extreme caution when installing the IMM module. The
module is fragile and can be damaged easily.
IMM connector
Hole for standoff
8510522.book Page 87 Wednesday, March 16, 2005 11:19 AM