Filter
Top Products
Paper and Ribbon
Roll paper utilizes the metal racks, which come as
accessories with every Gemini printer. As shown in Figure 2-4,
these accessories include the paper guide, paper separator,
roll-paper holder, and holder shaft. For information on how to
attach these accessories, please refer to Appendix G.
The steps for inserting roll paper are fairly simple and
straightforward:
1. Turn the power “off:’
2.
Remove the tractor unit, if you haven’t
already done so.
3.
Following the procedures described in
Appendix G,
attach the paper
separator, guide, and holder.
4.
Pull the release lever (located on the left
side of the top-front part of the printer)
into the “open” position. As with single-
sheet paper, the “open” position is
indicated by the letter “TV
5.
Lift the paper press.
6. Pull the paper separator upright, as
depicted in Figure 2-4 (for the
Gemini-lox). The paper guide should
remain horizontal.
7.
Load the paper roll, as shown in Figure
2-4, so that when viewed from the
printer’s right side, the paper will unroll
in a clockwise direction.
8. As shown in Figure 2-5 (for the
Gemini-15X), unroll some paper and
pass it above the paper guide and
underneath the up-ended paper
separator.
19