Filter
Top Products
Gemini User’s Manual
After typing your text, you may go either to the second menu,
which will permit you to print your text, or to the third menu where
you may send Escape or control codes to the printer for special
characters or effects. It is not necessary to type the entire ASCII
codes. Instead, you have the option of selecting “ESC” or “CHR$“.
For example, if you wish to send CHR$(27); “W”; CHR!$(l); to the
printer for printing of wide characters, you simply need to seiect
the “ESC” option and type “Wl” and then hit c CR>, and the code
will be sent to the printer. After sending the codes, you may gc
back to the 2nd menu and print your text again.
The following is a listing of the commands:
-
CONTROL COMMANDS FOR THE “DO-IT-YOURSELF”
WORD PROCESSING PROGRAM (SHOWN IN FIGURE 5-4)
1st MENU
A P = gets you to the 2nd command level
AD = deletes the character to the left of the cursor
AR = restart: clears the screen and lets you type a new text
*E = exits the program
2nd MENU
P = prints your text
C = gets you to the 3rd command level
R = returns you to the 1st print level
3rd MENU
E(ESC) = lets you send ESC code with an abbreviated
command
C(CHR$) = lets you send a control code with an abbreviated
command
R = returns you to the 2nd level
These commands may vary if you are not using an IBM-PC, but
the effects will be the same. For further explanation of the program
variations, please refer to the computer-specific appendices at the
back of this manual.
78
-
-
-
-