Filter
Top Products
Paper and Ribbon
Gemini-l 5X Loading Sprocket Paper
The Gemini-15X can be loaded with sprocket paper exactly the
same as can the Gemini-lox, but with one important difference.
*
The Gemini-15X is designed to accept paper either from the back
of the printer or paper fed from beneath the printer. That’s right,
there’s a slot in the undercarriage that lets you position the
Gemini-15X above your stack of fanfold computer paper; this paper
is fed up through the printer and out the back.
Following are the steps for loading sprocket paper to and
through the Gemini-15X. Figure 2-11 illustrates steps 1 through 6.
1.
2.
3.
4.
5.
6.
7.
8.
Turn the power “off?
Install the tractor unit, as illustrated in
Figure 2-7 (on page 23).
Attach the paper separator and paper
guide (they are the two metal racks that are
described in Appendix G).
Pull the release lever, located on the left
side of the printer, toward the “open”
position (marked “T”).
Raise the paper press.
Lift up the paper separator.
Raise the tractor covers on the sprocket
mechanisms (as shown in Figure 2-12).
Snap the clamp levers (atop the sprocket
mechanisms) forward to the open position,
and move the sprocket mechanisms away
from each other until there is enough room
between them to accommodate the paper.
27