Filter
Top Products
Chapter 12 Troubleshooting
105
Shaded rectangle
represents the position
of switch
Not Used (Default =Off)
BIOS Recovery
Clear Password
Clear CMOS
Not Used (Default = Off)
Not Used (Default = Off)
Not Used (Default = Off)
Not Used (Default = Off)
Figure 12-2. Configuration Switch Positions
Resetting a Lost Password
If you have forgotten the Power-on password, you can reset it using the
configuration switch on the system board.
NOTE If you have forgotten the Power-on password, your Netserver
will function normally, but you will not be able to access the
configuration settings in the Setup Utility or complete the boot
process if you reboot the Netserver.
1. Turn off power to the HP Netserver.
2. Remove the cover.
3. Move switch 3 in the configuration switch on the system board (labeled
"Clear Password") to the ON position. See Figures 12-1 and 12-2.
4. Turn on power to the Netserver and allow it to complete its startup routine.
The old password will be erased.
5. Turn off power to the Netserver.
6. Return switch 3 on the system board to the OFF position.
7. Replace the Netserver cover.
8. Turn on power to the Netserver and allow it to begin its startup routine.
9. If you wish to set a password again, press <F2> to start the Setup Utility.
10. Set the new password.
11. Choose the Exit option and save the changes to save the new password.