Filter
Top Products
Chapter 10 Configuring the HP Netserver
92
12. Choose Exit Saving Changes from the list of exit options, then press Enter.
A dialog appears and asks you to confirm your decision.
13. Choose Yes and then press Enter.
Then the HP Netserver reboots.
Setting the HP Netserver's Boot Passwords
Use this topic to set a password to boot the HP Netserver.
To configure the HP Netserver for a password, which will require a password on
boot-up, refer to the following procedure.
1. If not already in the Setup Utility, boot or reboot the system and press F2
when prompted.
2. Use the right-arrow or left-arrow key to select Security from the menu bar.
As soon as it is selected, the selections for the Security menu appear as
shown below.
➢
➢➢
➢Power-On Password
➢
➢➢
➢
Hardware Security
The arrowhead ➢ indicates there is a submenu to select from.
3. If necessary, use the arrow key to move to the Power-On Password menu
selection and press Enter.
The Power-On Password is highlighted by default when the Security menu
is selected.
The first line in the menu is, "Power-on password is [Set or Not Set]"
a. If no password has been set, then "Not Set" will appear in the field. If this
is the case, then you can boot the Netserver without a password.
The Power-on password controls access to the Setup Utility and its
settings, but will not be in effect until you reboot the Netserver.
b. If "Set" is in the field, then you can change the password or remove the
password, if you know the exiting password. If you do not know the
existing password, then refer to "Resetting a Lost Password" in Chapter
12, "Troubleshooting."
NOTE You must set the Power-on Password to configure the HP
Netserver to boot with a password.