Filter
Top Products
Chapter 10 Configuring the HP Netserver
90
o Integrated I/O Port - Configure ports for serial and parallel, assign base
addresses and interrupts, pointing devices (mouse), and console
redirection for remote control.
o Flexible Disk Drive
- Enable or disable the flexible disk drive controller.
o CPU and Memory
- Enable or disable memory cache, memory hole, and
processor serial number.
o IDE Devices
- Set primary master/slave, secondary master/slave
relationships on IDE devices, and set the local bus IDE adapter.
o PCI Slot Devices
- Set a PCI slot as master and PCI IRQ locking. The
BIOS warns of conflicts.
o Boot Device Ordering
- Set the boot order, including bootable boards.
o Embedded LAN Controllers
- Enable or disable the embedded LAN
controllers and the available features. The Alert-on-LAN 2 (AOL 2) and
Wake-on-LAN features are enabled/disabled under the embedded LAN A
submenu.
• Exit – Exit the Setup Utility by saving changes or exit without saving
changes, which reverts to previous settings. When you exit, the HP Netserver
reboots.
Using the Setup Screens
Online help explains the settings displayed on the Setup Utility screens.
Instructions are also provided for navigating between the screens and entering or
changing the setup data.
• Press the right-arrow and left-arrow keys to move between selections on the
menu bar. The menu bar is present at the top of the main selections.
• Press the up-arrow and down-arrow keys to move between fields on each
screen. The currently-selected field will be highlighted.
• Certain fields ask you to choose from a list of entries. In such cases, press the
plus (+) or minus (-) keys repeatedly to display each possible entry, or the
Enter (or Return) key to choose from a pop-up menu.
• Small arrow points (➢
➢➢
➢) precede some field names. This means the field is
actually a submenu. To visit the submenu, select it with the arrow keys and
press the Enter key. The submenu then appears in place of the current
screen.
• The Esc key is the exit key. If you press the Esc key on one of the
top-level screens, the Exit menu appears. If you press Esc on a submenu, the