Filter
Top Products
Chapter 4 Installing Additional Memory
32
WARNING Ensure you hold the DIMM tightly as you push it into the slot.
It is possible to turn or bend the DIMM slightly while
inserting it, which would damage or break the DIMM socket.
If a DIMM socket is damaged, you must use another DIMM
slot or replace the entire HP Netserver, since this Netserver is
not repairable in the field.
11. Holding the DIMM at approximately 30° to the system board, press the DIMM fully
into the slot until the retaining latches close. See Figure 4-4.
If the latches do not close, the DIMM is not inserted correctly.
NOTE The system board is shown removed from the Netserver for
clarity.
0
1
2
3
DIMM
Slots
System
Board
Figure 4-4. DIMM Insertion
12. Repeat Steps 7-11 to install all of the DIMMs for your memory configuration.
13. If you have completed the DIMM installation, close the Netserver and return it to the
rack where power can be applied.