Filter
Top Products
Chapter 3 Installing Mass Storage Devices
20
Installing Hot Swap Hard Drives
Use this section to install the SCSI hard drives in the Hot Swap drive bays.
CAUTION Protect the drive from static electricity by leaving it in its
anti-static bag until you are ready to install it. Before handling
the drive, touch any unpainted metal surface to discharge
static electricity. When you remove the drive from the anti-
static bag, handle it only by the frame.
Do not touch the electrical components. Place the drive on the
anti-static bag whenever you set it down.
1. Remove the filler panel from the desired drive bay location:
a. Place a thumb and index finger on the tab latches on the sides of the filler
panel, as shown in Figure 3-2.
b. Press in on both tab latches to release the filler panel.
c. While keeping both tab latches depressed, pull the filler panel out of the
drive bay. See Figure 3-2.
Tab Latches
Figure 3-2. Releasing the Filler Panel's Tab Latches