Filter
Top Products
Chapter 3 Installing Mass Storage Devices
22
CAUTION To prevent snapping off the ejector arms do not apply
excessive pressure.
5. Close the ejector arms by rotating each one back into place. See Figure 3-4.
6. Verify the tab on each ejector arm engages the edge of the drive bay as you
close it. See Figure 3-4.
Locking tab pivots
when ejector arm
is opened or closed.
Drive Ejector Arms
Closing
Ejector Arm
Figure 3-4. Closing Drive Ejector Arms
7. If the drive is unseated in the drive bay after closing both ejector arms, repeat
this procedure from Step 2 to 5.
The ejector arms may not have opened enough to engage the tab, or the SCSI
connector failed to engage the SCSI connector at the rear of the Hot Swap
drive bay.
NOTE Closing both ejector arms will ensure the drive connector
engages the electrical connector in the Hot Swap drive bay and
seats the drive.