Filter
Top Products
Chapter 13 Alternative Rack Mounting (4–Post)
116
Figure 13-2. Releasing Spring Assembly
Marking the Columns
Use this section to mark the front and rear columns of the HP Systems rack. The
outer-rails mount to the face of the front columns and the inside face of the rear
columns. The masking tape (or marking pen) is used to identify and mark the
locations on the columns.
CAUTION If other rack components are to be mounted in the rack below
the HP Netserver, install those components before starting to
mount the Netserver.
NOTE Use the HP Rack Configuration Tools to determine where in
the rack to mount the HP Netserver.