Filter
Top Products
83
9 Connecting the Monitor, Keyboard,
Mouse, and UPS
Introduction
Use the procedures listed here to connect the peripheral devices to the
HP Netserver LP 1000r.
1. Connect the monitor, keyboard, and mouse to the HP Netserver LP 1000r
using the connections provided on the rear of the chassis. See Figure 9-1.
When connecting the Netserver to peripherals, use the cable ties and labels
provided with the product.
NOTE The two USB connectors are reserved for printers, scanners,
and external modems, but not the keyboard or mouse.
Power Mouse Parallel LAN A/MGMT LAN B
PCI Slot (1)
Keyboard Serial A/MGMT Video External
SCSI Connector
Figure 9-1. Rear Panel Ports
NOTE If you have a console switch box, refer to the switch box user
guide for instructions on connecting the keyboard, mouse, and
monitor.
CAUTION The Keyboard and Mouse ports are both PS/2 ports, but are
not interchangeable. If you plug the keyboard into the Mouse
port, or the mouse into the Keyboard port, you will get an
error message and the system will not finish the boot process.
2. Connect the power cord to the rear of the Netserver. See Figure 9-1.
3. If LAN cables are needed, you may connect them now or wait until you have
verified the Netserver's operation.