Filter
Top Products
35
5 Installing Additional Boards
Introduction
The HP Netserver LP 1000r provides one 64-bit PCI slot connected to a riser board on
the system board, which will handle a full-length 32-bit or 64-bit PCI accessory board.
Tested PCI Boards
For a list of tested PCI boards, check for compatibility in Configuration Assistant on the
Navigator CD-ROM or look for the Hardware Tested Products list for the HP Netserver
LP 1000r under the Service and Support topic for the specific NOS used in the Netserver
at HP’s web site:
http://www.hp.com/netserver/support/
CAUTION Some accessory board outputs may exceed U.S. National
Electrical code (NFPA 70) Class 2 or limited power source
limits and must use appropriate interconnecting cabling in
accordance with the National Electrical Code.
NOTE All Hewlett-Packard accessory boards comply with the U.S.
National Electrical code (NFPA 70) Class 2.
Also refer to the Readme file and Configuration Advisor on your HP Netserver
Navigator CD-ROM. Refer to Chapter 10, "Configuring the HP Netserver," for
instructions.
Tools Required
The following tools are only needed when removing or adding an accessory board in the
HP Netserver:
• An anti-static service kit (3M 8501/8502/8503 or equivalent). This kit
includes a static-dissipating work surface, a chassis clip lead, and a wrist
strap.