Filter
Top Products
Chapter 10 Configuring the HP Netserver
93
4. Press the Enter key to enter a new password or change the old one.
A pop-up menu appears titled, "Set Power-On Password". If no password
has been entered, the field "Enter new password: [ ]" is highlighted. If
a previous password has been entered, the field "Enter old password:
[ ]" is highlighted.
NOTE To leave the pop-up menu without entering a password, press
the Esc key at any time.
5. Enter the password (new or old) in the appropriate field and press Enter.
The password is accepted and the next field just below it, "Re-enter new
password: [ ]" or "Enter new password: [ ]" field is highlighted.
For security reasons, the password does not appear on the screen.
6. Enter the new password in the "Enter new password: [ ]" field.
NOTE Entering nothing in the "Enter new password" field followed
by entering nothing in the "Re-enter new password" field will
turn off the password setting, changing it to "Not Set."
7. Enter the new password again in the "Re-enter new password: [ ]" field.
The "Power-on Password is" field changes to "Set" and on the next boot
the HP Netserver requests a password to access the Setup Utility and
complete the boot process.
8. Press Esc to exit the menu and scroll to Exit to exit and save changes.
The Netserver will reboot and you will be required to use your new
password to enter the Setup Utility or complete the boot process. If you
forget your password, refer to "Resetting a Lost Password" in Chapter 12,
"Troubleshooting."
SCSI Configuration Utility
The HP Netserver uses the Symbios SCSI Configuration Utility to verify or
modify the embedded SCSI controller settings for the devices connected to the two
SCSI channel connectors on the system board. If you need to verify or modify
SCSI host adapter settings, or if you need to low-level format SCSI disks or verify
SCSI disk media, run the Symbios Configuration utility: