Filter
Top Products
Chapter 2 Opening and Closing the HP Netserver
12
Figure 2-2. Removing the Top Cover
Replacing the Top Cover
To replace the top cover, follow these steps:
1. If the HP Netserver is already laying on a flat surface with no power applied,
continue with Step 5.
2. If the HP Netserver was operating with the cover removed, power down the
operating system and turn off the Netserver's power switch.
3. Disconnect the power cord and any cables attached to the Netserver.
4. Remove the Netserver chassis from the rack and lay it on a flat surface.
5. Ensure the knob is turned to the "Open" position (clockwise position).
See Figure 2-2.
Place the rear edge of the top cover on the rear edge of the chassis and lay it
down on the chassis.
6. Rotate the knob to the "Closed" position (counter clockwise position).
See Figure 2-3.